Turning Power On/Off - Sharp PN-L702B Setup Manual

Caution
• Turn on the monitor first before turning on the PC or
playback device.
Turning on the main power
Caution
• The main power must be turned on/off with the main power
switch. Do not connect/disconnect the power cord or turn
the breaker on/off while the main power switch is on.
• When switching the main power switch or the POWER
button off and back on, always wait for at least 5 seconds.
• For a complete electrical disconnection, pull out the main
plug.

Turning power on/off

Press the POWER button to turn the power ON/OFF.
Touch panel power LED
• Status of the power LED
Status
Green lit
Orange lit
Green flashing
• Status of the touch panel power LED
Status
Green lit
Blinking orange
Alternately blinking green and
orange
Off
Turning Power On/Off
Main power switch
Power
button
Power LED
Status of the monitor
Power on
Power off (Standby mode)
Input signal waiting mode
Status of the touch panel
Operating normally
Initializing
Touch panel off (power not
supplied, etc.)
nDate/time setting
• If the time has yet to be set when the monitor is first turned
on, the date/time setting screen appears. Set the date and
time.
DATE/TIME SETTING
/ /
SET 01 / 01
CANCEL
1. Press , ,
time, and press or
values.
2. Select SET and then press
• Be sure to set the date and time.
• The date/time setting screen will close automatically if no
operation is performed for about 15 seconds. The date
and time can be set using DATE/TIME SETTING from
the OPTION menu when the date/time setting screen
disappears.
TIPS
• Set the date in "Month/Day/Year" order.
• Set the time on a 12-hour basis.
• The clock is maintained by the internal battery.
• If you already set the time but the date/time setting
screen appears when the power is turned on, the
internal battery may be exhausted. Please contact
your local Sharp servicing dealer or service center for
assistance with battery replacement.
• Estimated service life of the internal battery: About 5
years (depending on monitor operation)
The initial battery was inserted at the factory when the
•
monitor was shipped, so it may run out of power before
its expected operation life.
: :
/ 20 11 12 : 00 AM
OK···[MENU]
or to select the date and
to change the numerical
MENU .
7
E