Wyse WY-60 User Manual page 16

Table 2-5
Continued
COMM Setup Parameters
Table 2-6 Miscellaneous Setup
Parameters (IBM Personalities) 1
Parameter Explanation
XMT HNDSHAKE
When sending data to a device connected to the
MODEM port, the terminal
NONE Ignores all incoming software handshaking
signals
XON/XOFF Responds to X-on/X-off handshaking
XPC HNDSHAKE When the terminal is in PC Term mode,
OFF The receive handshaking protocol depends on
the RCV HNDSHAKE parameter setting of
the port configured as the data port
ON Special codes (Hex 65 and Hex 67) are sent in
place of X-on/X-off handshaking protocol for
the data port
Parameter Explanation
ENTER
Pressing E N T E R sends the code defined by the
RETURN RETURN parameter (in this setup level)
SEND SEND parameter
INSERT 2
Pressing I N S E R T
MODE Turns on insert mode
SPACE Inserts a space character at the cursor position (cursor
doesn't move)
PRINT
2 Pressing P R I N T sends to the printer the contents of the
VIEWPORT Viewport
SCREEN Screen
PRINT EOL 2
When the terminal executes print viewport, print screen,
or print page commands,
ON The line terminator defined by the LINE END
parameter is sent to the printer
OFF No line terminator is sent
PRINT LINE END 2 When the terminal sends data to the printer, the line
terminator is an ASCII character for
CRLF
Carriage return (CR) and linefeed (LF)
CR Carriage return (CR)
PRINT NULL 2 When sending data to the printer, the terminal
ON Doesn't send null characters
OFF
Converts null characters to space characters
1 Parameters displayed when the terminal is in an IBM personality.
2 IBM 3161 only.