Wyse WY-60 User Manual page 14

Table 2-5 C O M M Setup Parameters
Parameter Explanation
AUX BAUD RATE
9600
19200
110
134.5
150
300
600
1200
1800
2000
2400
3600
4800
7200
The AUX port baud rate is
AUX DATA/STOP BITS
8/1
7/2
8/2
7/1
Through the AUX port, the terminal sends and
receives
8-bit data with one stop bit
7-bit data with two stop bits
8-bit data with two stop bits
7-bit data with one stop bit
AUX PARITY 1
NONE
ODD
MARK
EVEN
The terminal sends data to the AUX port with
No parity bit
Odd parity
A high (mark) parity bit
Even parity
AUX RCV HANDSHAKE
DSR
BOTH
NONE
XON/XOFF
The terminal controls the receipt of data from a
device connected to the AUX port by
DSR handshaking (raising and lowering the
DSR line voltage)
Both X-on/X-off and DSR handshaking
No handshaking protocol
X-on/X-off handshaking
AUX XMT
HANDSHAKE 2
NONE
XON/XOFF
When sending data to a device connected to the
AUX port, the terminal
Ignores all incoming software handshaking
signals
Responds to X-on/X-off handshaking
1 The terminal ignores any incoming parity bits.
2 The terminal always responds to DTR handshaking signals through the AUX port.