Wyse WY-60 User Manual page 11

Parameters
Explanation
END-OF-LINE WRAP
ON
OFF
ENHANCE
ON
OFF
FONT LOAD
ON
OFF
INIT TABS
OFF
ON
MONITOR
OFF
ON
PERSONALITY 2
When additional characters are entered at the end of
a line,
The cursor wraps to the start of the next line
Characters at the cursor position are replaced
In the nonnative terminal personalities, an enhanced
set of codes is
Recognized by the terminal
Not recognized by the terminal
When changing personalities or the number of
displayed lines, the terminal
Loads the appropriate character set
Doesn't change the current character set
When the terminal is turned on, tab stops are
Cleared
Initialized from nonvolatile memory
The terminal
Executes escape sequences and control codes
Displays symbols for escape sequences and
control codes without acting on them 1
The terminal can run programs written for the
following terminals:
WY-60 Itself (native mode)
WY50 + WY-50, WY-50 + , WY-100
T V I 9 1 0 +
TeleVideo910and910 +
T V I 9 1 2 / 9 2 0 TeleVideo912and 920
TVI925 TeleVideo 925
TVI 950 TeleVideo 950
TVI 955 TeleVideo 955
PC TERM P C / X T / A T type
ADDS A2
ADDS Viewpoint A2
ADDS VP60
ADDS Viewpoint 60
HZ 1500
Hazeltine 1500
D G 2 0 0 Data General DASHER D100 and D200
D G 2 1 0 Data General DASHER D210
ADM-31 Lear Siegler ADM 31, ADM 3A, ADM 5
1 See WyseWorks ASCII Table for symbols displayed.
2 When you select a new terminal personality, the terminal displays the appropriate character set
unless the FONT LOAD parameter is set to off.
3 Caution The terminal may clear the entire display memory when you change its personality.