Advertisement
ANDERIC® DC1 + DC8 Installa2on Instruc2ons
TRANSMITTER OPERATION
Remove the baDery cover from the remote control
transmiDer and install baDeries. Replace the cover.
Note: Use two 1.5V/AAA ba2eries (included).
Note: If not used for an extended ?me, remove the
ba2ery to prevent damage to the remote transmi2er,
and store the remote transmi2er away from excess heat
or humidity.
DIMMING / NON-DIMMING SETTING
The "DIM" selecJon is the light dimmable selecJon; the
light will cycle from bright to dim to bright unJl the
buDon is released. The "ON" selecJon is only the light ON/OFF (non-dimming funcJon). Light
will maintain the last seVng if turned off.
Note: The remote control is preset with light dimming func?on enabled at the factory.
Note: Ensure electricity is turned off before installing the receiver (Refer to the ceiling fan
instruc?ons).
UNIVERSAL MODE AND LEARNING MODE
There is a "Universal Mode" and "Learning
Mode" with the remote control. When
selecJng "Universal Mode," simply place
the dip (code) switch at the UPPER posiJon
(COMMON CODE). Your fan remote control
is ready to use.
Note: If using universal mode, your fan can
be controlled with other remote
transmi2ers in the same seKng.
To control the fan with a specific remote
transmiDer, choose "Learning Mode" by
placing the dip (code) switch at the LOWER
posiJon (L. CODE) and then select the
funcJon seVng as below.
Learn funcJon seVng: Restore the power
source to your fan, press and hold the
"LEARN" buDon for at least 3 seconds. You
must press the "LEARN" buDon within 60 seconds of restoring power to the fan.
Copyright 2023 – Dan's Electronics Etc., Inc. – Anderic.com
DC1+DC8
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Anderic DC1
Summary of Contents for Anderic DC1
- Page 1 “LEARN” buDon for at least 3 seconds. You must press the “LEARN” buDon within 60 seconds of restoring power to the fan. Copyright 2023 – Dan’s Electronics Etc., Inc. – Anderic.com DC1+DC8...
- Page 2 = Medium low speed = Medium speed = Medium-high speed = High speed = Fan Off key. = Forward/ Reverse key - This buDon controls the direcJon of the fan rotaJon. Copyright 2023 – Dan’s Electronics Etc., Inc. – Anderic.com DC1+DC8...
- Page 3 4. When turning the fan on or operaJng the forward/reverse funcJon, it is normal for the fan to rotate and run in both direcJons for approximately 1 minute and then stop. Copyright 2023 – Dan’s Electronics Etc., Inc. – Anderic.com DC1+DC8...
- Page 4 A`er compleJng the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmiDer, please turn the power off to the receiver and repeat the pairing process. Copyright 2023 – Dan’s Electronics Etc., Inc. – Anderic.com DC1+DC8...
- Page 5 Turn off the power at the breaker. Wire up the second fan and unwire the first fan. Turn on the power at the breaker. Press and hold the Learn buDon on the second fan’s transmiDer. If there are more fans, repeat the same procedure for all the fans. Copyright 2023 – Dan’s Electronics Etc., Inc. – Anderic.com DC1+DC8...
Need help?
Do you have a question about the DC1 and is the answer not in the manual?
Questions and answers