Page 1
Applicable for models: RRH100, RRH200, RRHC100, RRHC200 Introduction We want to thank you for purchasing this Universal Hospitality remote by Anderic®. With the purchase of this remote you should receive a screw for the battery cover. Battery cover screw is optional; battery cover does not need screw to hold it in place. This remote requires two AAA size batteries, not included.
Page 2
adheres under the battery cover for a secure and flush appearance. Pre-programmed Codes This remote is pre-programmed by default to LG and VIZIO TVs under TV mode and DirecTv under STB Mode (Set-Top-Box). If the TV or STB is not one of the brands above, you must program the remote using the directions below: NOTE: If [S] key is not present on your remote, note that it is the unmarked button to the right of the [POWER] key.
Page 3
3. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and remains on, release both keys. 4. Repeatedly Press [CH+] to search forwards or [CH-] to search backwards; remote will send the code of POWER one by one. 5.
Page 4
Single Press Combined POWER Key About: This allows for powering on/off both your TV and STB (Set-top-box) with one press of the [POWER] button. If enabled, pressing [POWER] key will send code for power for both units. If disabled, pressing [POWER] key will only send code for TV.
Page 5
TV Punch-Through Function About: When enabled, this feature allows assigning all TV related keys to always send codes programmed under TV mode, no matter what mode the remote currently resides. This feature has been enabled by default. Keys affected are Power, VOL+, VOL-, Mute, Input and Sleep. Follow steps below to enable or disable this feature.
Page 6
Individually Assign Punch-through Unlock 1. Press and hold [S] and [ENTER] keys simultaneously for about three seconds until indicator light lights and remains on, release both keys. 2. Input the three digits [9] [0] [0], 3. Press the button you want to unlock the punch-through, the LED will blink one time & turn off. Device Mode Lock About: This is used to lock the code for the device so they cannot be re-programmed.
Page 7
2. Input code [9] [7] [6] [2]. Indicator light will blink 3 times, indicating that the remote has successfully been reset to factory default status and converted to a 2-Device remote. LEGAL: Anderic® is a registered trademark of Dan’s Electronics Etc., Inc. All rights reserved. This document is copyrighted.
Page 8
TV CODES Note: These codes can only be programmed under TV mode. Admiral 1917 1927 Advent 1933 Akai 1930 1939 1999 2025 1964 1985 2029 2032 2073 Apex Digital 1931 1934 1952 2065 Audiovox 1926 1937 2011 2012 2021 2035 Aventura 1922 Broksonic...
Need help?
Do you have a question about the RRH100 and is the answer not in the manual?
Questions and answers