Draining Remaining Water And Cleaning The Pump Filter - Beko B3WFU58415W User Manual

4.4.5 Draining remaining water and cleaning the pump filter

The filter system in your product prevents solid items such as buttons, coins and fabric fibres clogging the
pump impeller during draining of washing water. Thus, the water will be drained without any problem and the
service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water should be drained completely.
Foreign substances left in the pump filter may damage your product or may cause noise problem.
In regions where freezing is possible, the tap must be closed, system hose must be removed and the water inside the
WARNING:
product must be drained when the product is not in use.
After each use, turn off the tap to which the mains hose is connected.
In order to clean the dirty filter and drain the water:
1 Unplug the product to cut off the supply power.
A
Temperature of the water inside the product may rise up to 90 ºC. To avoid the risk of scalding, clean the filter after the
water inside the product is cooled down.
2 Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product doesn't have an emergency water draining hose, in order to drain the water:
4 Clean any residues inside the filter as well as fibres, if any, around the pump impeller area.
5 Replace the filter.
6 If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
32 / EN
1 Close the taps.
2 Remove the nuts of the water intake hoses to
access the filters on the water intake valves and
clean them with an appropriate brush. If the filters
are too dirty, remove them from their places with a
pliers and clean in this way.
3 Take out the filters on the flat ends of the water
intake hoses together with the gaskets and clean
thoroughly under running water.
4 Replace the gaskets and filters carefully and
tighten their nuts by hand.
a Place a large container at the end of the hose to
collect the water from the filter.
b When the pump filter starts leaking water loosen
it by turning (opposite clockwise). Fill the running
water to the container you placed in front of the
filter. Keep a cloth ready to clean the water that
may spill.
c Completely turn and remove the pump filter
when the water in the product leaks out.
Washing Machine / User's Manual