Selecting Whether The Genlock Reference Input Is Terminated - evertz 7700 Manual

7700 MultiFrame Manual
7751SRG-HD HD-SDI Tri-Level Sync Generator
6.3.

SELECTING WHETHER THE GENLOCK REFERENCE INPUT IS TERMINATED

TERM/UNTERM: The TERM/UNTERM jumper J2, located on the A7700REF Genlock sub-module, is
used to terminate the genlock input. Then it is in the TERM position a 75 ohm
terminating resistor will connect the input to ground. When it is in the UNTERM
position the genlock input will be high impedance.
Page - 10
Revision 1.5.2