CHAINTECH 7KJD Manual page 16

Clear CMOS Data (JP1)
CPU Bus Frequency (JP3)
Power-On By Keyboard (JP5)
1
Normal
To clear the contents of the CMOS, please follow
the steps below.
1. Disconnect the system power supply from the
power source.
2. Set the jumper cap at location 2~3 for 5 seconds,
then set it back to the default position.
3. Connect the system's power and then start the
system.
4. Enter BIOS's CMOS Setup Utility and choose
Load Setup Defaults. Type Y and press enter.
5. Set the system configuration in the Standard
CMOS Setup menu.
1
100MHz (default)
This jumper allows you to select the system bus
frequency speed of your CPU. Set the jumper cap
to pins 1-2 for 100MHz FSB, set the jumper cap to
pins 2-3 for 133MHz FSB.
1
Disable(default)
This board is able to be turned on by the PS/2
keyboard (hot key). To use this function, select
a hot key of your choice at the PS2KB Wakeup
option under Wake Up Events in BIOS's Power
On Management screen. You must also set this
jumper's cap to pins 2-3 to use this function.
Hardware Setup
1
Clear CMOS data
1
133MHz
1
Enable
13