Before Connection - Sony RM-E300 Operating Instructions Manual

Before Connection
The editing controller, player, recorder and the monitor (or TV) are connected as follows.
Monitor (TV)
Recorder
* Connect the RM-E300, player and recorder as the above
illustration. For details on the connection, see the following
pages.
+ Use a Sony product equipped with the CONTROL L ( or
REMOTE) for the player.
* When the CONTROL (L or S) connector is not equipped
with the recorder, control the recorder remotely with an
infrared remote contro] unit.
RM-E300
Notes on connection
+ Be sure to supply the power to the recorder and the player
from a wall outlet (using an AC pack if necessary). Never
use battery packs for the power source as they may
discharge during of editing.
* Connect the red plug to the right jack, the white plug to the
left jack and the yellow plug to the video jack.
Note on power connection
Disconnect the AC power adaptor after the power of this unit is
turned off so that the memorized data is not erased.
Note on the AC power adaptor
If an AC power adaptor not manufactured by Sony is used, a fuse
must be installed in the adaptor cord and the polarity of the plug
must be as illustrated.
Polarity of the Sony's plug