Daewoo HURRICANE CAT 2 User Manual page 10

2. Fully unravel the Mains Cable (15) and insert the
mains plug into the nearest mains socket and switch
the socket on (if applicable).
3
4. Hold the Multi Tool (1) by the handle and hold it over the area to be cleaned.
5. Press and hold the Water Release Trigger (3) on the underside of the handle to
expel water through the Spray Jet (2).
NOTE: Do not spray water continually in the same place, as the water will quickly
be absorbed after spraying. If the water penetrates too deeply and is not
sufficiently re-absorbed, mildew could start to form.
6. Once the area is sufficiently saturated,
release the Water Release Trigger (3).
Press the Multi Tool (1) evenly and firmly
against the material. Pull the handle
slowly towards you, keeping it pressed
against the carpet or upholstery to
vacuum up the water. The dirty water
will go into the Dirty Water Tank (8).
7. Repeat step 5 & 6 if necessary if the spot
to be cleaned requires further cleaning.
If the spot mark is heavily soiled, use a separate solution for heavily soiled areas
such as Daewoo Carpet & Upholstery Stain Remover
contacting Daewoo Customer Services on 0161 831 7879 or email
10
3. Press the On/Off Switch (6 – arrowed left) to
power up the Spot Washer.
6
help@daewooelectricals.com.
IMPORTANT – RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
650W Hurricane 1.4L Spot Washer
2
which is available by
Model No. FLR00155
User Manual