Tips - Philips Cineos 55PL9874 User Manual

Tips

Blinking orange
indicator
Poor Picture
Digital distortion
No picture
No sound
No Surround
sound
No solution found
for your picture or
sound problem ?
Menu
TV
NEX IEW
Remote control
Standby
The TV lamp is worn out, dead or has expired and needs to be replaced.
• Have you selected the correct TV system in the manual installation menu?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio
equipment or neon lights, etc.?
• Mountains or high buildings can cause double pictures or ghost images.
Sometimes you can improve the picture quality by changing the direction of the
aerial.
• Is the picture or teletext unrecognisable? Check if you have entered the correct
frequency. See Installation, p. 6.
• Are brightness, sharpness and contrast out of adjustment? Select Factory
settings in the Setup, General menu, p. 9.
• Sometimes poor picture quality is possible when having activated an S-VHS
camera or camcorder connected to your TV and another peripheral is
connected to one of the externals at the same time. In this case switch off one
of the other peripherals.
The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart
Picture, without changing the picture settings manually.
• Is the aerial connected properly?
• Are the plugs tightly connected in the aerial socket?
• Is the aerial cable in good condition and does it have suitable plugs?
• No sound on any channel? Check the volume isn't at minimum.
• Is the sound interrupted with the mute key ¬?
• Perhaps the channel is not broadcasting good quality surround sound.
• No sound from the rear speakers or the centre speakers? Select an appropriate
surround mode, according to the broadcasted sound signal or adjust the
volume. See Surround Modes, p. 12.
Switch your TV off and then on again once. Never attempt to repair a defective
TV yourself. Check with your dealer or call a TV technician.
Have you selected the wrong menu? Press the
menu.
No TV info:
NEX IEW
See Acquisition and updating of
Displayed time is wrong:
The broadcaster on programme number one does not transmit the correct local
date and time. Use Reshuffle in the installation menu to place another broadcaster
on programme number one.
• If your TV no longer responds to the remote control, the batteries may be dead.
• Check if the remote control is in the correct mode.
• You can still use the
Your TV consumes energy in the standby mode. Energy consumption contributes
to air and water pollution.
Power consumption: 1 W
TV information, p. 15.
NEX IEW
key and the -/+ keys at the top of your TV.
MENU
key again to exit from the
MENU
27