Table of Contents
Advertisement
Annex : Care of the set
24
Cleaning or replacing the filters
Your TV has two air filters that cover air inlets on the bottom
of the set. Maintaining a free flow of air through the inlets is
very important. Allow 10 to 15 cm of space behind the TV for
air flow through the back slots.
The filters must be maintained and eventually replaced.
Clean the filters with a vacuum cleaner.
L
DVI
R
SUB
OUT
CENTER
Replace the filters if vacuuming does not sufficiently clean them.
IN
RGB+HV
(The part number for the Philips TV inlet filter assembly is
STANDARD/
HD INPUTS
TUNER
STANDARD/
HD INPUTS
3135 037 51810).
If the air filters become dirty, clogged or blocked the
temperature in the set will rise. Should the heat level become
too high due to blockage, a sensor will detect this and a
warning message will appear on screen. Check the air inlets for
blockage.The message will reappear every 15 minutes as long as
the temperature remains too high.
If the temperature remains too high for 1 minute, a warning
message alerting you that the TV is shutting down will appear.
The TV will enter Standby mode.The TV is off.
&
Place your fingers under one of the filter slots located at either
bottom left or right in the back of the TV cabinet.
é
Grasp the filter and gently pull it straight out.
"
Examine the filter for dust or other contamination. If it is dirty,
clean it. Replace the filter if necessary.
Warning: DO NOT operate the TV without filters. Damage to the
TV will occur.
'
Turn the filter so that the arrow is pointing towards the centre
of the TV. Align the edges of the filter with the slot track, then
gently slide it all the way back into the slot. A click can be heard
as the filter reaches the correct position.
them.
DO NOT WASH
Advertisement
Table of Contents
