Table of Contents
Advertisement
BIOS Setup
Change Supervisor Password
This item lets you configure the system password
which is required every time when the system boots up
or an attempt is made to enter the Setup program. The
password cannot be longer than six characters.
Note: Keep a safe record of the new password. If you forget
or lose the password, the only way to access the system
is to clear CMOS memory by holding down the
<End> key then powering on to reboot the system.
Auto-Detect Hard Disks
If your system has an IDE hard drive, you can use this
utility to detect its parameters and automatically enter
them into the Standard CMOS Setup. This utility will
autodetect up to four IDE devices.
Save Settings and Exit
Select this item to save the values entered during the
current session and then exit the BIOS setup program.
Exit Without Saving
Select this item to exit the BIOS setup program without
saving the values which has been entered during the
current session.
31
Advertisement
Table of Contents
