Table of Contents
Advertisement
ATX Functions & Connectors
J4 (21, 22) – ATX Power Button and Suspend
Switch Connector
Attach the ATX Power Button or Suspend Switch cable
to this connector.
In the AT power system, this connector will act as a
suspend switch; and in the ATX power system, this
connector will be not only an ATX power button but a
Suspend switch as well. Details are described below:
When the system is off, push the power button to turn
the system on. When the system is on, push the power
button rapidly to switch the system to the Suspend
mode, and, by pushing and holding the button for
more than 4 seconds, it will turn the system completely
off. When the system is in the Suspend mode, push the
power button rapidly to turn the system on.
J2 – Wake On LAN Connector
While in Soft-off/Suspend state, if an external LAN
signal occurs, the system wakes up and can be accessed
with the LAN card.
Pin
1
2
3
11
Description
5V Stand By
Ground
Active High
Advertisement
Table of Contents
