Input Selector - Yamaha CX-1000 Owner's Manual

INPUT SELECTOR
To select a source for listening or watching, press sither end
(<Jorf>-) of the INPUT SELECTOR until the desired source
is indicated on the input indicator @.
Input sources can be selected directly with the supplied remote
control unit (see below).
This continuously variable loudness control allows you to
compensate for the human ear's loss of sensitivity to low and
high frequencies at low volumes. It lets you progressively at-
tenuate the middle range in order to retain a natural balance
with the bass and treble when listening at low levels. Normally,
this control should be set to the FLAT position. See below for
operation details.
input indicators
These indicate the source selected with the INPUT SELECTOR
ER Normally, these indicators are red. However, when the
VIDEO switch @ is on and the audio source selected is different
from the video source, the respective video source indicator
will turn green. |
NOTE: č čć
When VIDEO switch on, one of the green video source (VCR :
or CDV) indicators always remains lit, even if you select
an audio source. This means you can listen to the sound
of the selected audio equipment while simultaneously
watching the picture of the indicated video source.
REC OUT selector
Determines which source will be recorded by the connected
tape deck(s), DAT recorder(s) or VCR(s). In the SOURCE po-
sition, the source currently selected with the INPUT SELECTOR
€) is recorded. Use the SOURCE position when you want to
make an analog recording of a digital signal.
When not recording, leave this rotary switch in the OFF posi-
tion. |
Any signals selected with REC OUT (except in the SOURCE
position) are fed directly to the rear panel TAPE OUT,
TAPE/DAT OUT and/or VCR OUT jacks, regardless of the
current INPUT SELECTOR setting. This means you can listen
to or watch any source while recording another.
For details on recording and dubbing, see OPERATIONS.
@ SOURCE DIRECT switch and indicators
Pressing this switch routes the audio input signal directly to
the CX-1000 output stage, bypassing the tone controls, sub-
sonic filter and the mode, loudness control circuits thus giving
the purest possible sound. lts indicator will light.
Remember that none of the controls just mentioned will have
any effect when SOURCE DIRECT is pressed, except MUTING.
NOTE:
lf the LOUDNESS control is currently being used, pressing
SOURCE DIRECT will have the effect of suddenly raising the
volume.