Voltage Selector - Yamaha CX-1000 Owner's Manual

SAFETY INSTRU
Keep this manual in a safe place for future
reference.
Avoid placing your CX-1000 in direct sunlight
or close to a source of heat. Also avoid lo-
cations in which the device is likely to be
subjected to excessive dust, cold or mois-
ture.
The openings on the cabinet ensure the
ventilation of the amplifier. If these openings
are obstructec, the temperature inside the
cabinet will rise rapidly and eventually
damage the circuits. Therefore, avoid plac-
ing objects against these openings and do
not install your amplifier in a place such that
the flow of air through the ventilation
openings could be impeded.
SS Power cord
When removing the power plug from the wall
outlet, always pull directly on the plug. Never
yank the cord as this may result in damage
to the cord and possibly a short-circuit.
lf you do not intend to use this unit for an
extended period of time, it is advisable to
unplug the power cord.
El Switches and knobs
Avoid applying excessive force to the
switches and knobs.
E Relocation
Before moving your amplifier, be sure to
unplug the power cord and remove all other
connecting cables.
@ Troubleshooting Chart
Consult the Troubleshooting Chart for advice
on the common operation errors before
concluding that your amplifier is faulty.
E Servicing
Do not open the cabinet or attempt to make
repairs by yourself, as this may aggravate
the damage and expose you to an electrical
shock.
Object and liquid entry
See to it that foreign objects or spilled liquids
do not enter inside the cabinet. Should this
case arise, consult your YAMAHA dealer.
Wipe off dust with a dry soft cloth. To remove
dirt or fingermarks, use a soft damp cloth
then dry immediately with a clean cloth. Do
not use alcohol, thinners or other chemical
solvents since they may damage the finish
or remove the panel lettering.
Do not use any aerosol sprays near this unit
as these products can easily get into the unit
and damage the circuitry.
VOLTAGE SELECTOR
(General Model only)
The voltage selector switch on the CX-1000
rear panel must be set for your local voltage
BEFORE plugging in the AC mains supply.
Voltages are 110/120, 220/240V AC, 50/60Hz.
EY S
110V~120V 220W-240VW
VOLTAGE SELECTOR
Special instructions
for the U.K.
THE WIRES IN THE MAINS LEAD ARE
COLOURED IN ACCORDANCE WITH THE
FOLLOWING CODE: |
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains
lead of this apparatus may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured BLACK. The
wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured RED.
A"