Roland LA SOUND MODULE CM-32L Owner's Manual page 2

For the U.K.
BLUE : NEUTRAL
BROWN : LIVE
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
For West Germany
Bescheinigung des Herstellers/Importeurs
Hiermit wird bescheinigt, daß der/die'das in Übereinstimmung mit den Bestimmungen der
LA SOUND MODULE CM-32L Amtsbl. Víg 1046/1984
(Geral Тур. Bezeichnung} (Amtsblattverfugung)
funk-entstórt ist
Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerátes angezeigt und die Berechtigung zur Überprulung
der Serie au! Einhaltung der Bestimmungen eingeräumt.
Roland Corporation Osaka/Japan
Name des Herstellers imponeurs
For the USA
RADIO AND TELEVISION INTERFERENCE
WARNING — 0 Tris equipment has been verified 10 comply wih the limits for a Class B computing device. pursuant to Subpart Ј of Рап 15. cC FOC rules, Operation with
non-certifien or non-venhed equipment is likely to result in interference Io radio and TV reception
The equipment described in this manual generates and uses radio frequency energy. Н itis not installed and used properly. that is. in stict accordance with our instructions,
и may cause interference with radio and television reception. This equipment has been tested and found to comply with the hmits [or а Class В computing de: n accordance
with the sperifications in Subpart J ol Part 15. of FCC Rules. These ruies are designed to provide reasonable protection against such а interference m a rasi
iai installation
However. there 15 no guarantee that the interference will not occur in а particular installation. И this equipment does cause imere! е югайо or television reception, wich
can be determined by luring the equipment оп and ой the user 15 encouraged to try to correct the interference by the following ute
Disconnect other devices and ther
pul output cables one al a time. ff the interference stops. itis
sed by either the other
or its LO са
These devices usually require Roland designated shielded ІО cables For Roland devices you can сіна the proper shielded cable пон your dealer For aon Roland
devices. contact the manufacturer or dealer for assistance
Н your equipment does cause гиеНегепсе 10 evision reception. you can try to correct the interference by using one or more of thy
Turn the TV or radio antenna until the interference stops
Move the equipment to one side or the other cl the TV or radio
Move the equipment farther away from the TV or radio
Plug the equipment into an Outlet that is опа different сиси than the TV or radio. (That is. make certain the equipment and the radio or television set are on circuits Con:
trolled by different circuit breakers or fuses j
Consider installing a rooftop television antenna with coaxial cable leadan between the antenna and TV. Н necessary.
you should consult your dealer or an experenced
racdioAetevision Technician tor addilinnal suggestions. You may trg helpful the following booklet prepared by the Federal Communications Commission
"How to Identity and Resolve Radio — TV interference Problems"
This booklet is available from the US
Government Panting Office. Washington, ОС.
20402. Stock No. 004-000-00345-4
owing measures
For Canada
CLASS B NOTICE
This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference
Regulations of the Canadian Department of Communications.