GE JGSP23 Installation Instructions Manual page 17

Gas slide-in range
Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions
J | Making the L.P. Gas Conversion
Broil
Burners
1. Use a screwdriver to loosen the air shutter
screw.
2. Adjust the air shutters. The table below gives
the recommended initial air shutter setting.
Your final settings may vary.
INITIAL AIR SHUTTER SETTINGS
J6|
Air Shtter Setting for Bake and
Gas Supply
Location
Dim. "A"
LP Gas
Broil burner
7/16"
Bake burner
5/16"
Natural
Broil burner
5/16"
Bake burner
3/16"
a
'~
(adjust at the
opening nearest the
air shutter screw.)
Air Shutter
Adjustment Screw
3. Retighten the air shutter screw.
Bake and broil flame must be checked with
the door closed to properly check flame
characteristics.
4. Turn on the bake or broil burner.
a. If the flames are yellow, open the air
shutter more.
b. If the flames blow away or flutter from the
burner close the air shutter more.
WARNING:
If you attempt to measure
the inner cone
of the flame,
please
use caution; burns could result.
5. Checking the flame size.
Check the inner cone
Inner Gone of Flame
of the flame. It should
we To sia"
be approximately 1/2"
"
Burner
to 3/4" long for the
oven and broil burners.
lf the flame size is incorrect,
recheck all conversion steps.
YELLOW! FLAMES
Call for Service
suicHT YELLOW
SOFT BLUE FLAMES
Normal for Natural Gas
Normal fon 'P Gas
6. When all adjustments are made and the results
are satisfactory:
a. Replace the orifice fitting cover
b. Replace the oven baffle (flame spreader)
c. Replace the oven bottom.
IN SOME
CASES
1. With L.P. gas, some yellow tipping on the outer
cone is normal.
2. Foreign particles in the gas line may cause an
orange flame at first, but this will soon disappear.
SPECIAL NOTE:
To convert the oven back to natural gas, reverse the
instructions given in making L.P. Adjustments.
Once the conversion
is complete and
checked ok, fill out the L.P. sticker and
include your name, organization and date
conversion was made.
Apply the sticker to the
range near the regulator to alert others in the
future that this appliance has been converted to
L.P.
If converting back to natural gas from L.P.,
please remove the sticker so others know the
appliance is set to use natural gas.
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jgsp44

Table of Contents