Advertisement
Available languages
Available languages
CJ5010
cause unpredictable effects during operation, resulting in health hazards. Keep the battery pack away
from open flames and high temperature. If exposed to fire or temperatures above 130°C, the battery
pack may explode.
Installing the battery pack
Tip: Using a battery pack incompatible with the power tool may result in abnormal performance or
failure of the power tool.
Insert the battery pack into the handle until the battery pack latch clicks (the battery pack should be
flush with the receptacle edges on the power tool).
Blade installation:
Make sure the device is disconnected from the power source.
The device is equipped with a rapid blade installation system (SDS).
Turn the SDS chuck.
Place the blade in the chuck.
Release the SDS clamping ring.
When replacing the blade make sure that:
The blade holder is free from other materials
Always check that the blade is securely clamped before use.
Blade removal:
Remember to wait after work because the blade may be hot.
Make sure the device is disconnected from the power source.
Rotate the saw blade chuck SDS ring
and remove the blade from the chuck.
Operating the device:
1. Insert the plug into the wall socked and then press the button (5) to turn the device on
2. The tool features a debris blower at the cutting area to remove debris from the workpiece during
operation. Start the debris blower by moving the switch (1) to the blower mode.
3. To set the undercutting, select the movement of the blade pendulum to the material that will be
worked on. Adjustment in the range of 0-3 is possible, with the knob in mode 0, the undercutting is
disabled, and in mode 3 the undercutting is at the top range. The undercutting is used for faster and
easier cutting of materials.
Do not cut hard materials such as metal in the undercutting mode.
4. The machine allows cutting at an angle 45 . To cut at an angle:
Make sure the device is disconnected from the power source.
Loosen the fixing screws at the bottom of the foot until the foot can be extended, set the position
you need.
Move the foot to the position you want to get.
Tighten the fixing screws.
INSTALLING THE GUIDE
Make sure the device is disconnected from the power source.
Place the guide in the front of the foot in the holes provided for this purpose.
Set the guide size you need to achieve and then tighten the fixing screws.
CLEANING AND MAINTENANCE
o
10
Advertisement
