Advertisement
Warning
！
1. Use clean air.
Do not use compressed air that contains chemicals, organic solvents based synthetic oils, salts or
corrosive gases, etc., as this can cause damage or malfunction.
Caution
！
1. Install air filters.
Install air filters close to valves on the upstream side. A filtration degree of 5 micrometer or less should be
selected.
2. Install an aftercooler, air dryer or drain catch before the filter.
Compressed air that contains excessive drainage may cause malfunction of valves and other pneumatic
equipment. Therefore, take appropriate measures to ensure air quality, such as by providing an after
cooler, water separator.
3. If excessive carbon powder is seen, install a mist separator on the upstream side of
the valve.
If excessive carbon powder is generated by the compressor, it may adhere to the inside of the valves and
cause malfunction.
4. Use the product with the specified fluid and within the fluid and ambient temperatures
specified range.
5. Grease is applied to the inner parts of the valve.
Grease may enter on the downstream side of the valve.
For detailed information regarding the quality of the compressed air described above, refer to
"SMC's Cleaning Systems".
Warning
！
1. Do not use in an environment where corrosive gases, chemicals, sea water, water or
steam are present.
2. Do not use the product in an environment where flammable or explosive gas exists.
Use of the product in such an environment may cause a fire or an explosion. The
product does not have an explosion proof construction.
3. Do not operate in a location subject to vibration or impact.
4. Use a protective cover, etc. to shield the product from direct sunlight.
5. Shield the product from radiated heat generated by nearby heat sources.
6. Do not use the product in an environment where foreign matter may adhere to or get inside
the product.
7. Employ suitable protective measures in a location where there is contact with oil or
welding spatter, etc.
Air Supply
Operating Environment
6
Advertisement
