Hyundai 7BL-300 Manual page 24

Chapter I. Safety information and warning
SAFETY INFORMATIONS & WARNINGS
1. Training
1) Read the instruction manual carefully. Fully familiar with all operating
mechanisms and the correct use of machines. Master how to shut down and quickly
separate the operating mechanism.
2) It is forbidden for children to use this product. Never allow adults who have not
read the instructions to use this product.
3) Keep the work area clear of people, especially children and pets.
2. Preparation
1) Comprehensively check the area where the machine will be used and remove all
sundries.
2) Before starting the transporter, please check that the wires are not damaged or
short-circuited.
3) Before starting the engine, place the clutch handle in the disengaged state and
set the gear position to neutral.
4) Do not operate the machine without wearing a proper jacket. Wearing non-slip
shoes will improve the stability of your footing on slippery surfaces.
5) When the engine is running, no adjustments are allowed (except for special
adjustments recommended by the manufacturer).
6) Drinking alcohol is forbidden, and work when unwell. In addition, operations by
persons unsuitable for driving and working are prohibited.
3. Operation
1) Hands and feet must not be close to or placed under the rotating parts.
2) Turn the flameout switch to the open position, increase the throttle
appropriately, close the choke, set the gear to neutral, pull the rope to start the
engine, then open the choke, select the appropriate gear, and slowly increase the
throttle And depress the clutch handle, the transporter starts to operate normally.
3) Be especially careful when manipulating on (or crossing) gravel roads, sidewalks
or highways, be alert to potential dangers, pay attention to traffic conditions, and
do not carry passengers.
4) After hitting the debris, stop the transporter and check whether the transporter
is damaged. If the damage is repaired, the transporter can be restarted and
operated.
5) Always pay attention to your feet to avoid slipping or falling.
6) Once the machine experiences abnormal vibration, immediately stop the
transporter to find the cause. Vibration is usually a precursor to failure.
7) When the truck needs to change gears, the clutch handle must be released first
E NGLISH
E NGLIS H
24
26
1