ZOLL PD 1200 Operator's Manual page 40

not
discharge.
40
switch. No
portion of the hand should be on the top surface of the unit near the paddle plates.
l
Press each DISCHARGE button individually and verify that the unit does
dischame ome the
200 joules.
WARNING
When performing this check using paddles, place hands on the paddle handles as
shown in the picture below. Use vow thumbs to
44501, you can further test the pacer output cable and verify pacer
calibration.
DELIVERED ENERGY AND DISCHARGE BUTT'ONS CHECK
l
Perform this check once a week.
l
Place the SELECTOR SWITCH in the 200 joules position.
l
Verify that the adult paddle electrodes or multi-function electrode cable is installed.
l
Leaving the paddles in their holders or, as appropriate, plugging the multi-function
electrode cable into its test jack, press either CHARGE button. Wait for the " CHARGE
READY' tone to sound and the CHARGE INDICATOR LIGHT to light and verify that
the DELIVERED ENERGY display on the monitor registers
ZMI's PACEMAKER TEST
LOAD (Part No. NTP
mA. The 'PACE LEAD OFF" message should appear.
The above tests quickly verify basic pacer functions.
If you have
mA. There should be no 'PACE LEAD OFF' message.
l
Slowly turn the knob up to 15
4:l button and verify that the frequency of pulses decreases (8 large divisions,
4 cm per pulse).
l
Turn the OUTPUT knob to 0
OPERATORS GUIDE
zyxwv
PACER OPERATION (BASIC)
l
Turn
the SELECTOR SW ITCH to
PACER ON.
l
Turn RATE knob to 150 ppm and press the MARK button to generate a strip.
l
Verify that the pace pulses occur approximately every 10 small divisions (2 large
divisions, 1 cm).
l
Press the