Electrical Safety - Black & Decker BEW230K-QS Manual

When using any tool for prolonged periods ensure you
take regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing dust developed when
u
using your tool (example:- working with wood, especially
oak, beech and MDF.)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured in
accordance with a standard test method provided by EN62841
and may be used for comparing one tool with another. The
declared vibration emission value may also be used in a
preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following symbols are shown on the tool, along with the
:
date code:
Warning! To reduce the risk of injury, the user
must read the instruction manual.

Electrical safety

#
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. On/off switch
2. Dust extraction connector.
3. Base
4. Tip holder
5. Sanding base tip
6. Finger attachment*
7. Screw
8. Diamond shaped tip
(Original instructions)
In addition, this tool is supplied with some or all of the
following accessories:
Accessory Recommended application and use
Coarse grit Fast paint, varnish and rust removal
sandpaper
Medium grit Paint, varnish and rust removal
sandpaper
Fine grit Surface blending and finishing
sandpaper
Extra fine grit Sanding between coats
sandpaper
Detail sanding tips Corners and hard to reach places
1 OT polishing/ Polishing metals, stripping varnish
stripping wool and glass cleaning
Grey foam pad Applying and removing polish
Red non-woven Heavy scrubbing and rust removal
pad
Grey abrasive Polishing plastics
paper
*Please Note: The finger attachment (6) may not be
included in all units. All accessories are available from your
BLACK+DECKER dealer or via our website:
www.blackanddecker.co.uk
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting sanding sheets (fig. A & B)
Detach the two diamond-shaped tips (8) from the
u
sanding sheet (9).
Hold the tool with the sanding base facing upwards.
u
Place the sanding sheet (9) onto the sanding base,
u
making sure that the holes in the sheet line up with the
holes in the base.
The diamond-shaped tip (8) can be reversed and replaced
when worn.
When the front part of the tip is worn, detach it from the
u
sheet, reverse it and press it onto the sanding base again.
When the whole tip is worn, remove it from the sanding
u
base and fit a new tip.
The polishing foam and pads (14) can be fitted the same
u
way as the sanding sheets.
Tip of the sanding base (fig. D)
When the sanding base tip (5) or tip holder (4) is worn, it can
be reversed or replaced. Spare parts are available from your
BLACK+DECKER dealer.
ENGLISH
5