Table of Contents
Advertisement
Underscore Spoke
Hammer
Adjustment Screw
Daisywheel Motor
Daisywheel
| 1.5-2.0 тт
T HHHHH
„с к.
Ribbon Tape
Drive Cam
| 1
[Иш]
Adjustment Screw
©
Ribbon Holder
(Top View)
3-6
3.13
Daisy Home Position Adjustment
Each spoke must be directly aligned with the Ham-
mer when its character key is depressed.
If neces-
sary or when installing a new motor, adjust as fol-
lows.
Important Note:
The Daisywheel Motor must only be adjusted
in the "DAISY ADJ" mode with power sup-
plied to the motor.
In the "DAISY ADJ" mode
the Daisywheel motor will be energized for 2
minutes, after that the display will read "PWR
OFF/ON".
This message will remain until the
power is turned off.
1
—
Install a Daisywheel and latch the motor in print-
ing position.
2) Initialize the Daisywheel as in section 3.12.
3) Press the SHIFT
+ REPEAT keys and turn on the
power at the same time. Display will read "DAISY
ADJ".
Manually
push
the
Hammer
toward
the
Daisywheel, and observe the underscore spoke
locator in relation to the Hammer groove.
If the
Hammer
is not aligned
with the underscore
spoke, follow the next step.
5) Align the Hammer groove with underscore spoke
locator by turning the Adjustment screw.
After
adjusting the position, observe the alignment by
repeating steps 2) 3) 4).
6) Apply a locking compound to the Adjustment
screw to prevent loosening.
4
—
3.14
Ribbon Lift Adjustment
The typed character must strike near the upper edge
of the Ribbon (See the illustration). Check by typing
several characters and observing their position on
the Ribbon.
1) The tops of capital letters should be 1.5 to 2.0
mm from the upper edge of the Ribbon.
2) Ifthe character is not in the proper position, ad-
just the position by turning the adjustment screw.
Turning the screw clockwise will raise the posi-
tion
of the
characters
on
the
ribbon
and
counterclockwise will lower the position.
Advertisement
Table of Contents
