Master/Slave Operation; Remote Control - Beamz SHOWBAR Instruction Manual

MASTER/SLAVE OPERATION

The Master/Slave mode allows a single ShowBar (the master) to control the actions of one or more ShowBar (the slaves)
without the need for a DMX controller. The master will be set to operate in either Automatic or Sound-Active mode, while the
slaves will be set to operate in Slave mode. Once set and connected, the slave units will operate in unison with the master.
Setting the slave-unit(s):
1. Press <MENU> repeatedly until Slav blinks on the display.
2. Press <ENTER> to put the fixture in Slave mode. The display will continue to blink.
3. Repeat steps 1 and 2 for every slave.
4. Connect the DMX output of the first slave unit to the DMX input of the next slave unit.
5. Connect the DMX input of each subsequent slave unit to the DMX output of the previous slave unit.
Setting the master-unit:
1. Connect the DMX output of the master to the DMX input of the first slave unit.
2. Set the master unit to operate in either Automatic or Sound-Active mode.

REMOTE CONTROL

BLACK OUT Mode
Press <BLACK OUT> off existing modes, Press <BLACK OUT> return the last modes.
AUTO Mode
Automatic mode will enable you to run the automatic programs on the product.
To turn on Automatic mode:
1. Press <AUTO> on the IRC.
2. Press <+> or <–> to choose between the different auto programs.
SOUND Mode
Sound-Active mode will enable the product to respond to the music.
To turn on Sound-Active mode:
1. Press <SOUND> on the IRC.
2. Press <+> or <–> to choose between the different SOUND programs.
STROBE Mode
To adjust the strobe speed of the automatic program and the sound active program.
1. Press <STROBE> on the IRC.
2. Press <+> or <–> to either increase or decrease the speed of the program.
3. Press <STROBE> again to turn off the strobe.
SPEED Mode
To adjust the speed of the automatic program and the sound active program.
1. Press <SPEED> on the IRC.
2. Press <+> or <–> to either increase or decrease the speed of the program.
SENSITIVITY Mode
To adjust sound sensitivity for in Sound-Active mode.
1. Press <SENSITIVITY> on the IRC.
2. Press <+> or <–> to either increase or decrease sound sensitivity.
DMX Mode
To enable DMX or disallow DMX on the product.
Press <DMX> on the remote controller, the product work on the DMX controlling modes.
Manual Mode
To manually control the RGBWAUV percentage:
1. Press <MANUAL> on the IRC.
2. Press <R>, <G>, <B>, or <W> (red, green, blue or white) to choose your colour.
3. Press <+> or <–> to either increase or decrease to choose your colour.
Number 1~6
Press digit <1> to turn on/turn off unit laser.
Press digit <2> to turn on/turn off unit white LED.
Press digit <3> to turn on/turn off unit Par 1.
Press digit <4> to turn on/turn off unit Par 2.
Press digit <5> to turn on/turn off unit Butterfly 1.
Press digit <6> to turn on/turn off unit Butterfly 2.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
7