Troubleshooting; Ese Ee) (Vsx-D701S U.s. And Canadian Models Only) - Pioneer VSX-D601 Operating Instructions Manual

TROUBLESHOOTING
incorrect operation is often mistaken for equipment malfunction. if you think that there is something wrong with this component, check the points
below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center or your dealer
to carry out repair work.
Symptom
Power does not come on even
when POWER switch is pressed.
Cause
® Power cord is disconnected.
* Instances are rare, but the problem may be due
to the Operation of the protector circuit.
Remedy
® Connect cord securely.
® Unplug the power cord of the unit from the AC
wail outlet, then plug it in again.
| Control was not possible
regardless of what operation
button was pressed.
e Static electricity affected the unit when the air
was dry, such as in winter.
No sound is produced, even
when the INPUT SELECTOR
button is selected.
© Connections are incorrect.
¢ The MUTING button is pressed.
* VOLUME is turned down,
e Unplug the power cord of the unit from the AC
wall outlet. then plug it in again.
° lf static electricity is pronounced, it is
recommended that you operate the unit using
the remote control unit.
Consult pages 7.
correctly.
* Press the MUTING button to cancel the MUTING
effec
Raise volume
- 13 and perform conne
fONS
* Speaker connecting wires are disconnected from
Speaker terminais.
Connect wires to terminals securely.
® Connect input cords securely.
| ° TAPE 2 MONITOR button is in the ON position.
—_
* The SPEAKERS button is OFF.
No picture is produced, even
when the INPUT SELECTOR
button is selected.
+
* Cannections are incorrect.
*® The V- SIGNAL SELECTOR is not set properly.
*® The VCR and the selected INPUT SELECTOR
button are not correct.
High noise level. . Station has not been tuned in to correct
frequency.
i
|
i
j
® Consult pages 7
correctly.
@ Set correctly.
* Prass the correct button
* Tune the station in correctly,
e Antenna has not been connected or has become
disconnected,
® Connect the antenna securely.
FM reception
| » Accessory T-type antenna remains bundied up
or it is not pointing in right direction.
e Weak broadcasting station signals.
® Replace accessory T-type antenna with outdoor
® Stretch both ends of antenna taut and locate |
direction yielding optimum reception.
FM antenna.
AM reception
¢ AM ioop antenna is not pointing in right
direction.
*® Weak broadcasting station signals.
® Change the direction af AM loop antenna and
find a position where reception is improved.
® Erect outdoor AM antenna or connect ground
wire.
¢ Noise being picked up from this unit and other
equipment {especially electrical appliances using
motors or fluorescent lights).
© Stop using appliances generating noise or remove
them from vicinity of the stereo equipment. |
® Separate the loop antenna from the unit by
some distance.
No auto stop. e Input signals are not strong enough.
© (FM) If 'the T-type antenna is being used, change
to an outdoor antenna
TV source can't be seen when
the VCR's TV tuner is used.
® TV antenna is not connected to VCR, or
connections are fauity.
° Consult the. VCR 8 operating instructions, and
connect antenna correctly,
| © You are attempting to watch a TV source using
a VCR with copy system connections.
In general, when copy system connections are
made, the VCR's TV tuner function ceases to
operate. For details, consult the operating
instructions for your VCR.
* Disconnect the copy system connection
(TV tuner function will operate).
Video tape copies can't be
made with the VCR.
¢ Video tape copy connections haven't been
made.
* Look again closely at the section VIDEO SYS! TEM
CONNECTIONS on page 9, and connect
< ARB1380>