Troubleshooting - Pioneer VSX-D507S Operating Instructions Manual

Turn OFF the power of
the system including
this unit.
Equipment is will turn OFF ac-
cording to the multi operation
settings.
»
Example: :
When you are using the remote control unit for VCR aperation, and VCR/TAPE is
set to 4)" in the Multi Operation table on page 39, this unit, TV and VCR will turn
OFF by this operation.
vor
e In esis devices that have been turned OFF, turning OFF the system will turn
ON the power.
@ All the PIONEER products will turn OFF, OOO)
@OOO®
QO @@'
Ea
(Co CS
SYSTEM OFF
© Pron
nants cera
"era rnrnrenerennen
Canceling remote control settings
Cancels settings that have been set or learned.
All multi control buttons of the
> remote control will blink. After
'\ blinking three times, all settings
will be canceled.
Cancel the set and
learned settings.
AU VAD
#
Py +
While pressing the
COMMANDER SET
UP button, press '0
for more than 3 sec-
onds .
Cancel the learned ee Cancel the settings that have
settings. yy" B > been learned only.
While pressing the
eae COMMANDER SET
UP button, press'?
e . for more than 3 sec-
7 ~ COMMANDER Ane.
SET UP
42
<ARET 166>
En
Seg nec Rotary Reaper ara
ocr wt al orp eine ch
| TROUBLESHOOTING
Symptom Cause
Remedy
The power does not turn
@ The power plug is disconnected from the
ON.
outlet.
@ The cause may lie in the protection circuit.
@ Insert into the wall outlet.
® Disconnect the power plug from the out-
let, and insert again.
The unit does not work
even when the buttons
are pressed.
@ Due to effects of static electricity when the
@ Disconnect the power plug from the out-
air is dry.
let, and insert again.
@ Refer to pages 12 to 14 and connect again.
@ Press the MUTING button on the remote
control unit.
@ Adjust MASTER VOLUME.
® Press the TAPE 2 MONITOR button.
@ Press the SPEAKERS button to select the
speakers.
@ Set the SPEAKERS button to match the set
of speakers connected.
@ The volume is turned down.
@ The TAPE 2 MONITOR is ON.
@ The speaker switch is OFF.
® The SPEAKERS button has been used to se-
lected speakers A and B (SP » AB), even
though only one set of speakers is connected.
@ Refer to pages 12 and 13, and connect
again.
@ The input source is not properly selected.
@ Press the correct button.
Considerable noise in ra-
@ Not received at proper frequency.
dio broadcasts
@ The antenna is not connected.
@ Receive the correct frequency.
@ Connect the antenna properly. (P.12 and 13)
@ Stretch out the antenna and secure it to a
faces an inappropriate direction.
wall while selecting the direction and po-
sition with the best reception state.
@ Change the FM antenna to an outdoor an-
tenna of multiple elements. (P. 12}
@ Weak radio waves.
[AM broadcast reception]
@ The AM antenna faces inappropriate direc-
tion,
@ Weak radio waves.
@ Select the direction and position with the
best reception state.
@ Connect a 5 to 6 meter (15~18 feet) long
vinyl-coated wire to the AM antenna ter-
minal and extend the wire outdoors, if pos-
sible. (P. 12)
@ Turn off the equipment which cause noise
or move it away from the unit.
® Distance the antenna from the equipment
which cause noise.
@ Affected by other equipment. (Fluorescent
lamp, motor, etc.)
Broadcast stations cannot
be selected automatically.
tenna of multiple elements. (P. 12)
43
<ARE7 166>
En