Connectors, Indicators And Labelling - RFI RX1317-3408-31 Series User Manual

Receiver Multicoupler User's Manual

2. Connectors, Indicators and Labelling

Front Panel Layout
RECEIVER MULTICOUPLER
1. Switch Control LED
2. USB Control LED
3. Fault LED
4. Power LED
Rear Panel Layout
1 2 3
POWER FAULT
USB
CONTROL
POWER ALARM
8 9 10 11
1. Power LED
2. Fault LED
3. USB Connector
4. Gain Switches
5. Expansion Port
6. RF Output
7. RF Input
8. Power Connector
9. Alarm Connector
10. USB Control LED
11. Gain Control LED
12. Earth Screw
13. Earth Stud
Figure 2 – Front Panel Layout
Yellow LED lights when the gain is controlled by the GAIN switches on the rear panel.
Yellow LED lights when the unit is controlled via the USB interface.
Red LED lights when a fault is present.
Green LED lights when correct polarity power is connected.
4 5 6
GAIN
EXP PORT
12
Figure 3 – Rear Panel Layout
Green LED lights when power is connected.
Red LED lights when a fault is present.
Type B connector to connect to a PC.
Rotary switches to manually set the gain.
N(f) connector to connect to an optional Expansion Multicoupler.
(Note: not fitted on model RX3852-3408-33-48)
One of eight N(f) connections to the receivers.
N(f) connection to the antenna (usually via a BP filter)
2-way Phoenix connector to connect to the DC power supply.
3-way Phoenix connector to connect to external alarm devices.
Yellow LED lights when the unit is controlled via the USB interface.
Yellow LED lights when the gain is controlled by the GAIN switches.
M5 screw for connection to an earth point.
M6 stud for connection to an earth point.
Asia Pacific | EMEA | Americas
1 2 3 4
USB
SWITCH FAULT POWER
RF OUTPUTS
7
RF INPUT
13
8