Receiver Multicoupler User's Manual
10. Operation
When the RxMux has been installed and connected to the Receiver Preselector (or Tower Top Amplifier) and Base
Station receiver(s), check all of the RF and DC wiring for correct connection and then the power source may be
switched on.
Check that the green "Power" LED light on the RxMux front (or rear) panel is illuminated.
All of the RxMux front panel LEDs will flash on shortly afterwards, and the remaining illuminated LEDs will reflect the
current state of the TTA and RxMux (and any current alarms).
The RxMux is now ready for configuration and commissioning (using the rear-panel gain switches, or via the USB
Command Line Interface (CLI) and operation.
Asia Pacific | EMEA | Americas
24