Safety - RFI RX1317-3408-31 Series User Manual

Receiver Multicoupler User's Manual

Safety

Only a suitably qualified person should be allowed to install and commission this equipment
after becoming familiar with all the safety and installation instructions contained in this
User's Manual.
It will be assumed that a qualified person will have a fundamental
knowledge of the installation's objectives and use common sense where safety warnings are
not necessarily explicit.
On unpacking the equipment, familiarise yourself with equipment, reading and following all warning labels attached to
the equipment. Please ensure that the warning labels are kept in a legible condition and replace if necessary.
Ensure all general, regional, and site-specific installation and safety regulations are adhered to when working on high
voltage installations, as well as regulations covering use of tools and personal protective equipment.
It is the responsibility of the network operator or service provider to have in place and implemented compliant
Occupational Health and Safety (OHS) / Work Health and Safety (WHS) procedures as applicable, detailing
prevention measures to avoid health hazards which may be associated with radiation from the antenna(s) connected
to this equipment. Please ensure familiarisation and compliance to country specific regulations on RF exposure.
It is recommended to ensure that access to this equipment is restricted to qualified personnel only.
WARNING: There is no on/off switch on this equipment – it becomes active as soon as
DC power is connected or the connected AC plugpack is switched on at the AC outlet.
Do not allow the unit or any associated equipment to become wet or to be subjected to
temperatures outside the specified operating temperature range.
Do not open the unit as there are no user serviceable parts inside.
All faulty equipment should be returned to RFI for repair.
Do not operate the unit near any flammable substances or in a flammable
atmosphere.
Ensure that all connectors are fully mated.
Under certain adverse conditions the external surfaces of the unit may become hot
and should not be handled without some form of protection, such as gloves.
Permanently hardwire one of the Protective Earthing points on the back panel to the
premises protective earth wiring. This connection provides protection from hazardous
and transient voltages.
Before installing or replacing this equipment the entire manual should be read and
understood. The user needs to supply the appropriate DC voltage to the equipment
and install it accordance with this manual.
Incorrect installation can damage the equipment and may cause injury to the user.
Asia Pacific | EMEA | Americas 6