Steffes 2100 Series Install Manual

2100 SERIES INSTALL GUIDE
DIRECT-WIRED ROOM HEATER
NOTE: Always transport the heater in an upright
position to avoid damage to internal components
and insulation materials.
1
PERSONAL SAFETY INSTRUCTIONS
SAFETY ALERT SYMBOLS
Three safety alert symbols are used to alert you to
personal safety instructions. They are:
• Electrical (1)
• Mechanical (2)
• Fire (3)
SIGNAL WORDS
Signal words that appear next to safety alert symbols are:
• DANGER
• WARNING
• CAUTION
• IMPORTANT
• NOTE
Carefully read and understand the instructions before you continue.
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Important
• The equipment described herein is intended for installation by a qualified technician in compliance with
applicable local, state, and national codes and regulations.
• Disclaimer: In compiling this manual, Steffes has used its best judgement based upon information
available, but disclaims any responsibility or liability for any errors or miscalculations contained herein,
or any revisions hereof, or which result, in whole or in part, from the use of this manual or any revisions
hereof.
2
SAFETY PRECAUTIONS
1. DO fully assemble the heater before energizing.
2. DO keep all explosive materials and/or flammable gases away from the heater.
3. DO maintain the placement and clearance requirements (Section 4).
4. DO keep items away from the discharge air grill area of the heater.
5. DO contact a qualified service technician for installation of this heater to ensure it is installed in accordance with
information contained herein and with national, state, and local codes and requirements.
1