TURNING HEATER "OFF" AND "ON"
2100 SERIES
Turning the heater "OFF" suspends all functions of the heater. To turn the
heater "OFF" use the down arrow to decrease the room temperature set
point until "OFF" is displayed on the faceplate. To turn the heater "ON" use
the up arrow to adjust room temperature set point to the desired
temperature. If desired, power to the heater can be shut off at the breaker
panel.
NOTE: The heater MUST remain "ON" if being used to supply a
peak control signal to other controlled loads. If utilizing the
Steffes time clock module and power is off to the
blower/control circuit for an extended period of time, it may
be necessary to reset the current day and time.
1000/2000 SERIES
You may wish to turn the heater off during the summer months. Brick core
charging and room temperature sensing can be turned off without
disconnecting power to the heater.
Using Automatic Charge Control
1. To turn the heater "OFF", use the down arrow button to
decrease the room temperature set point until the control
panel face plate displays "OFF".
2. To turn the heater back "ON", press the up arrow button to
adjust room temperature to the desired set point.
Using Manual Charge Control
1. To turn the heater "OFF", hold the M button until room temperature set point appears on the
TEMPERATURE digits of the faceplate.
2. Use the down arrow button to decrease the room temperature set point until the control panel faceplate
displays "OFF".
3. To turn the heater back "ON", press and hold the M and the up arrow buttons at the same time. When
room temperature set point displays on the faceplate, let go of the M button. Use the up arrow button to
adjust room temperature to the desired set point.
Page 1 of 2
Need help?
Do you have a question about the 2100 Series and is the answer not in the manual?
Questions and answers