Table of Contents
Advertisement
Chapter 5: Cell Connections
Normal Cell Connections
Each eQCM 15M is shipped with a standard, shielded BNC cable terminated with a ceramic adapter (P/N 985-
00124). Attach the male end of the cable to the front panel of the eQCM 15M (see Figure 5-1).
Quartz Crystal Installation
This section describes how to mount a quartz crystal in a Temperature Controlled QCM Cell (990-00400) and
shows the general assembly procedure for this cell type.
1. Attach vial-side plate to main block with two long screws. Tighten to snug-fit.
2. Attach side plate to main block with two short screws. Tighten to snug-fit.
Cell Connections
Figure 5-1
Connection of the BNC Cable to the Quartz
19
Advertisement
Table of Contents
