Tunturi J550 Owner's Manual page 5

Hide thumbs Also See for J550:

ASSEMBLY

INSTRUCTIONS

...CONTINUED

Refer to FIG. I, page 5

for

lefty

righty front &

rear orientations.

STEP 2 REMOVE RIGHT SIDE COVER(FlG. 2)_

Remove the screws that attach the Right Side Cover and Right

Front Roller Cover (3 screws total). Remove the covers.

STEPS INSTALL HANDLEBARS_

3A Hold the Right Handlebar in place at the front right corner

of the treadmill and secure it using the 50mni and 20mm screws

each with a flat washer. Insure the Steel Bushing is installed

between the front Right Handlebar base and the treadmill frame.

Be careful not to pinch or otherwise damage the ribbon cable that

comes out the bottom of the handlebar, (see FIG. 3)

Push the Left Handlebar inside the Plastic Merer Base

(attached to the Right Handlebar), being careful not to pinch

or damage the flat ribbon cable that runs inside the Right

Handlebar. Do not try to rotate the meter — this may cut the

ribbon cable. (See FIG. 4)

3C When the cop of the Left Handlebar is touching the top of

the Right Handlebar, tighten the pre-installed screws in the

bottom of the Meter Base, while insuring the Handlebars are

held securely together.

3D Attach the Left Handlebar to the Running Deck Side Rail

using the 80mm screw. Make sure that the cable operating the

Lift Motor is not pinched or forced to make any tight curves,

(see FIG. 5)

Plug connector from cable in Handlebar into connector

from Lift Motor.

3F Slide cable into clip on underside of frame.

3G Attach the Handlebar Bracket Cover by snapping it into

place over the lower end of the Left Handlebar.

TUNTURI J550 OWNER'S MANUAL