Samsung Hi8 SCL901 Owner's Instruction Book page 3

I ENGLISH I
Notices and Safety Instructions
9,
VENTILATION:
Slotsand openingsin the cabinet are providedfor
ventilationto ensure reliableoperation of the
CAMCORDERand to protectit from overheating.These
openingsmust not be blocked or covered. Never place
your CAMCORDERon a bed, sofa, rug, or other similar
surface:on or near a radiatoror heat register.
This CAMCORDERshould not be placed in a built-in
installationsuch as a bookcase or rack unless proper
ventilationis providedor the manufacturer's instructions
have been adhered to.
10. POWERSOURCES:
The CAMCORDERshould be operatedonly from the
type of power source indicated on the label.
If you are not sure of the type of power supply at your
home,consult your appliance dealer or local power
company.
A CAMCORDERis intendedto be operated from battery
power,or other sources, referto the operating
instructions.
11. GROUNDINGOR POLARIZATION:
This CAMCORDER may be equippedwith either a
polarized2-wireAC line plug (a plug havingone blade
widerthan the other) or a 3-wire grounding type plug, a
plug having a third (grounding)pin.
If you are unable to insert the plug fully into the outlet, try
reversingthe plug. If the plug still fails to fit, contact your
electricianto replace your outlet. Do not defeatthe safety
purpose of the polarizedplug.
12.
13.
POWER-CORDPROTECTION:
Power-supplycords should be routed so that they are not
likely to be walked on or pinched by items placedupon or
againstthem, paying particularattention to cords or plugs,
convenientreceptacles, and the point where they exit
from the unit.
OUTDOORANTENNA GROUNDING:
If an outside antenna or cable system is connected to the
CAMCORDER,be surethe antenna or cable system is
groundedto provide some protection againstvoltage
surges and built-up staticcharges, Section 810 of the
National ElectricalCode,ANSI/NFPANo. 70-1984,
provides informationwith respect to proper grounding of
the mast and supportingstructure, grounding of the
lead-in wire and supportingstructure, grounding of the
mast and supportingstructure, groundingof the lead-in
wire to an antenna dischargeunit, size of grounding to
conductors, locationof antenna-dischargeunit,
connectionto grounding electrodesand requirementsfor
the grounding electrode.
See figure below.