Pool Maintenance - Bestway POWER STEEL PLATINUM Series Owner's Manual

FILLING POOL WITH WATER
ATTENTION:
Do not leave pool unattended while filling
with water.
1. Fill the pool until the water reaches the welding line located 12 cm -
20 cm (4.7 in - 7.9 in) from the top of the pool. DO NOT OVERFILL
as this could cause the pool to collapse. In times of heavy rainfall
you may need to empty some of the water to ensure the level is
correct.
2. When filling the pool is completed, check that the water is not
collecting on any side to ensure the pool is level.
IMPORTANT:
re-level ground by digging out. Never attempt to move the pool with
water in it, serious personal injury or damage to the pool may result.
WARNING:
Your pool may contain a great deal of
pressure. If your pool has any bulge or uneven side then the pool is
not level, the sides may burst and the water may discharge suddenly
causing serious personal injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check any evident
water loss. Do not add chemicals until this has been done.

POOL MAINTENANCE

If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE:
Chemconnect or Chemical Floater must be used when you perform chemical maintenance with tablets. Your purchased item may
not include any of those dispensers, in this case you can purchase it by visiting our website www.bestwaycorp.com or at the nearest pool dealer.
IMPORTANT:
Don't use granulate tablets or throw the tablet directly in the water. The chemicals can deposit on the bottom, damage
the material and discolor the PVC.
Using chemical liquid (not included):
IMPORTANT:
Add chemical liquid in small doses and in the center of the pool to avoid direct contact between the chemicals and the
PVC surface. Direct contact can damage the material and discolor the surface.
NOTE:
Remove the chemical dispenser from pool when the pool is in use.
IMPORTANT:
After performing chemical maintenance and before using the pool, use a test kit (not included) to test the water
chemistry. We recommend maintaining your water according to the following table.
NOTE:
Damage resulting from chemical imbalance is not covered by the warranty. Pool chemicals are potentially toxic and should be
handled with care. There are serious health risks from chemical vapors and the incorrect labeling and storage of chemical containers. Please
consult your local pool supply retailer for more information about chemical maintenance. Pay close attention to the chemical manufacturer's
instructions. Pool damage resulting from misuse of chemicals and mismanagement of pool water is not covered by the warranty.
If pool is not level, drain water and
TEST
pH value
Cyanuric acid
Free chlorine
Chlorine compound
Algae
Calcium hardness
IDEAL VALUES
7.4 – 7.6
30 – 50 ppm
2 – 4 ppm
0
None visible
200 – 400 ppm
8
12 cm - 20 cm
(4.7 in - 7.9 in)
0°