Pepperl+Fuchs BTC22 Series Manual page 41

BTC22-*
BIOS Settings
Power Management
The system starts automatically when the power supply is turned on. In the event of a power
failure, the device will also automatically power up after the power supply has been restored.
Can be changed at section "Chipset" --> PCH-IO Configuration --> Power on after power fail
Add a screenshot too like BTC14 and BPC.
Figure 5.10
Save Options
Select "Save & Exit" from the BIOS setup page.
Save the changes and exit the system.
When you have finished making changes to the system configuration, save the changes using
the following instructions.
Saving Configuration Changes
1.
Select Save Changes and "Exit" using the arrow keys. Press ENTER.
2.
Select Yes. Press ENTER to save the changes and exit the system.
3.
Select No to exit the process without saving the changes.
The new system configuration settings take effect after the system is restarted.
Discarding Changes and Exiting the System
Use the following instructions to exit the system without saving the changes.
1.
Using the arrow keys, select Discard Changes and "Exit." Press ENTER.
2.
Select Yes. Press ENTER to discard the changes and exit the system.
3.
Select No to exit the process.
41