Fc-T Wired Timer Remote; Wired Timer Remote Operation - Chauvet DJ HURRICANE 1000 User Manual

Operation

FC-T Wired Timer Remote

The FC-T wired timer controller allows you to automatically trigger fog output by setting interval and
duration times. LED indicator lights display the machine and controller's current state. Rotary knobs set
interval time, output, and duration time, while manual and continuous buttons allow overriding control.
1. Plug the product in to power.
2. Plug the FC-T in to the wired controller socket on the back of the product. (See the
Overview.)

Wired Timer Remote Operation

The FC-T has three modes of operation: timer, continuous, and manual.
Timer Mode
To operate the Hurricane 1000 with the timer function:
1. Set the desired output level with the OUTPUT knob.
2. Set the INTERVAL and DURATION knobs to the desired positions.
• The INTERVAL knob sets the amount of time in between bursts of fog.
• The DURATION knob sets the length of time that the fog machine will run during the burst.
3. Press the <TIMER ON/OFF> latching button. The LED indicator above the button will light up.
4. Press the <TIMER ON/OFF> button again to turn off the timer.
The MANUAL Button will override the timer function.
Continuous Mode
To trigger the Hurricane 1000 to continuously output fog:
1. Set the desired output level with the OUTPUT knob.
2. Press the <CONTINUOUS> latching button. The LED indicator above the button will light up. The
fog machine outputs fog until the <CONTINUOUS> button is pressed again.
3. Press the <CONTINUOUS> button again to stop the fog output.
DO NOT run the product in Continuous mode for longer than 15 minutes. Continuous
mode must be followed by an equal amount of time without output (For example: follow 8
minutes of Continuous operation with 8 minutes of no output). DO NOT trigger the
product to output fog during that time.
• In order for Continuous mode to run uninterrupted, without the Hurricane 1000
stopping to reheat, set the OUTPUT knob no higher than 7. At Output levels above 7,
the fog machine will cycle through intermittent bursts of fog during its reheating
program.
• The duration of Continuous fog output is based on the capacity of the tank.
• Fluid consumption will be significantly increased during Continuous mode.
Manual Mode
To trigger the Hurricane 1000 manually with the FC-T:
1. Set the desired output level with the OUTPUT knob.
2. Press and hold the <MANUAL> button on the FC-T. The LED indicator above the button will light
up. The fog machine will output for the duration of the button press.
3. Release the <MANUAL> button to stop the fog output.
Hurricane 1000 User Manual Rev. 3
Uninterrupted continuous
mode at output 7 and below
Product
8