Advertisement
R
epair
[3] -5. Gear Assembly
DISASSEMBLING
1) Referring to "[3]- 3. Slider Section", remove Gear housing cover complete from Gear housing complete.
2) Remove two Plate C's by unscrewing four M5x14 Torx socket head screws with 1R314. (Fig. 21)
Note: It is recommended to use impact driver to remove the screws because they are coated with threadlocker.
3) The following parts can now be removed from Gear housing complete (Fig. 22);
Gear assembly, Needle bearing 708, Needle bearing 1012, Flat washer 14
Fig. 21
Plate C
Gear housing
complete
ASSEMBLING
Do the reverse of the disassembling steps.
Note:
a) Apply Makita grease FA No.2 to the following parts, before assembling:
*Flat washer 14: the surface that contacts Gear assembly
*Pin 10 (of Gear housing complete): surface that contacts Gear assembly
b) Torx socket head screw M5x14 is threadlocker coated. Therefore, if reusing the screw, be sure to apply adhesive
before tightening.
Fig. 22
1R314
Torx socket
head screw M5x14
Needle bearing 708
Gear assembly
Needle bearing 1012
Flat washer 14
Pin 10
P 8/11
Advertisement
