Advertisement
R
epair
[3] -3. Slider Section
DISASSEMBLING
1) After removing Shoe, then Insulation cover. (Fig. 13)
2) Remove the Blade clamp section. (See "[3] -1. Blade Clamp Section.)
Fig. 13
For smooth removal of Insulation cover,
apply soapy water into the space between
Insulation cover and Gear housing cover
complete.
Gear housing
cover complete
Insulation cover
3) Remove Gear housing cover complete from Gear housing complete by unscrewing four M5x25 Pan head screws.
(Fig. 14)
4) Remove two Plates from Gear housing cover complete by unscrewing four M5x16 Pan head screws. (Fig. 15)
Note: It is recommended to use impact driver to remove the screws because they are coated with threadlocker.
5) Disassemble Slider as illustrated in Fig. 16.
Fig. 14
Gear housing
cover complete
Gear housing complete
Fig. 16
Remove Plane bearing 14A
on the Motor housing side.
Plane bearing 14A
Slider
Insulation cover
(after removal of
Blade clamp section)
Fig. 15
Pan head screw
M5x25 (4pcs)
Plane bearing 14A
Slider
Push Slider toward
the Motor housing side.
Slider
Gear housing
cover complete
Pan head screw M5x16,
threadlocker coated
Plate
Gear housing
While raising this
end, pull off Slider.
Plane bearing 14A
P 6/11
Plate
Plane bearing 14A
cover complete
Advertisement
