Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Blade Clamp Section
DISASSEMBLING
1) Remove Shoe. If the Blade clamp section is positioned inside
Gear housing, pull it out of Gear housing. (Fig. 2)
2) After removing Protector, remove Retaining ring S-18 using 1R291.
Then remove the following parts:
Driving sleeve, Shoulder pin 5, Compression spring 6,
Pin 3 (of 6mm length), Guide sleeve, Driving sleeve guide
Now Sleeve can now be seen. (Fig. 3)
Fig. 3
Protector
Retaining ring S-18
3) Sleeve is still locked at this
stage. Therefore, release it
using a recipro saw blade
as illustrated in Fig. 4.
4) While putting your finger on the top of Slider to close the slit of Slider, remove Pin 3 (of 19.8mm length) by pushing
with a thin bar. (Fig. 5)
Note: Be sure to put your finger on the top of Slider or Push plate will pop out from the slit of Slider.
5) Remove Sleeve and Torsion spring 17 from Slider, then take Push plate and Compression spring 2 out of the slit of
Slider. (Fig. 6)
Fig. 5
Pin 3, 19.8mm long
Driving sleeve
(of 6mm length)
Fig. 4
[Sleeve Locked]
Recipro saw blade
Pin 3, 19.8mm long
Sleeve
groove
Fig. 6
Slider
Sleeve
thin bar
Torsion
spring 17
Sleeve
Slider
Fig. 2
Shoe
Pin 3
Guide sleeve
Sleeve
[Sleeve Released]
Push the recipro saw blade.
Now sleeve can rotate.
Pin 3 is positioned at
the lower end of the
groove on Sleeve
when Sleeve is released.
Push plate
Compression
spring 2
P 3/11
Blade clamp section
Shoulder pin 5
Compression spring 6
Driving sleeve guide
Advertisement
