Advertisement
R
epair
[3] -3. Slider Section (cont.)
ASSEMBLING
Do the reverse of the disassembling steps.
Note: a) Do not forget to apply Makita grease FA No.2 to slider before assembling. (Fig. 17)
b) Both of the two Plane bearing 14A's are not reversible when assembled to Slider.
Be sure to assemble as illustrated in Fig. 18.
Fig. 17
Surface that contacts
Needle bearing 708: approx. 7g
Surface that contacts
Plane bearing 14A: a little amount
[3] -4. Oil Seal 14, X Ring 14
DISASSEMBLING
1) Referring to "[3]- 3. Slider Section", separate Gear housing cover
complete from the tool.
2) Oil seal 14 can be removed by pushing X ring 14 toward the Blade
clamp side using a slotted screwdriver as illustrated to left in Fig. 19.
3) X ring 14 can now be removed by pushing toward the Blade clamp
side by hand as illustrated to right in Fig. 21.
ASSEMBLING
1) As illustrated to left in Fig. 20, assemble X ring 14 to Gear housing
cover complete from the Blade clamp side, then put Oil seal 14 onto
X ring 14.
Note: Oil seal 14 is not reversible when assembled to Gear housing
complete. Be sure to assemble so that the lip portion of Oil
seal 14 faces toward the Blade clamp side.
2) As illustrated to right in Fig. 20, set 1R250 on Oil seal 14,
then press down with arbor press until the end of the lip portion of
Oil seal 14 gets is flush with the top surface of the ring installation
hole of Gear housing cover complete.
Fig. 20
lip portion
Oil seal 14
X Ring 14
Fig. 18
Stepped portion
Plane bearing 14A
Blade clamp side
Motor housing side
Gear housing cover side
Stepped portion
Slider
Gear housing side
Fig. 19
Motor housing side
Oil seal 14
Blade clamp side
P 7/11
Plane bearing 14A
X ring 14
No.1R250
Advertisement
