Remote Assign Setting E; Local Address Setting - Yamaha DEQ5E Operation Manual

2. Remote Assign Setting
This sets how the DEQ5 "CONTROL SELECT" number and the DEQS(E) local address correspond to each other.
This is set in DEQS the "UTILITY" "REMOTE ASSIGN" menu.
CONTROL SELECT + GROUP# DEVICE #
If you set the "CONTROL SELECT" and the "DEVICE" number to the same value as shown in the table above, it
will be easy to understand how they correspond to each other.
In this case, the DEQS(E) Local address should be also set by selecting from the table above.
3. Local Address Setting
<Group number setting>
@ Hold down the front panel "GROUP" key for more than 2 seconds.
GROUP TS >
DEVICE
L (G) and the number displayed in the "DEVICE" LED will flash. A Group number may then be input.
Flashing will continue for approximately 2 seconds.
SUMA
FE,
o 9
Z F V NN
Flashing
@ Input a certain Group number by pressing the "GROUP" key several times, or hold the key down while the
LED display flashes.
Nos le Ab А
LSH
m 1 ` \ <
Flashing
@ A number you input will be set after approximately two seconds. Also, pressing the "DEVICE" key after a
number has been input will set the number. After 2 seconds, the display will light.
If you press the *DEVICE" key at this point, the device number will display, but the group number input in
step 2 will still be effective.
20