Check Ignition Of Surface Burners - GE EGR3000 Owner's Manual

Installation Instructions
ELECTRICALCONNECTIONS (CONT.)
B. Usage Situations Where Appliance Power Cord Will
Be Disconnected F requentlg.
Do not use an adapter plug in these situations because
disconnecting of the power cord places undue strain on
the adapter and leads to eventual failure of the adapter
ground terminal. The customer should have the 2-prong
wall receptacle replaced with a 3-prong (grounding)
receptacle bg a qualified electrician before using the
appliance.
The installation of appliances designed for mobile
home installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24 CFR,
Part 3280 (formerly the FederalStandard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280)or,
when such standard is not applicable, the Standard
for Manufactured Home Installations, latest edition
(Manufactured Home Sites,Communities and Set-Ups),
ANSIA225.1, latest edition, or with local codes. In Canada,
mobile home installation must be in accordance with the
current CAN/CSAZ240/MH Mobile Home Installation Code.
Electric Disconnect
II Locate disconnect plug on the range back.
II Pinch sides of connector and pull out of range back.
I-4--I SEAL THE OPENINGS
Seal ang openings in the wall behind the range and
in the floor under the range when hookups are completed.
[] CHECK IGNITION OF SURFACE
BURNERS
Operationof all cooktopand oven burnersshouldbe checked
after the range and gas supplglineshavebeen carefull U
checkedfor leaks.
Electric Ignition Models
Selecta top burner knoband simultaneousl Upush in and turn
to LITEposition.Youwill hear a clicking soundindicating proper
operationof the spark module.Oncethe air has been purged
from the supplglines,burnersshouldlightwithin 4 seconds.
After burner lights,rotate knobout of the LITEposition.TrU
each burner in successionuntil all burnershavebeen checked.
Qualitg of Flumes
ThecombustionqualitUof burnerflames needsto be
determinedvisuallg.
(A) Yellow flames--
Call for service
(B)Yellow tips on
outer cones--
Normal for LP gas
(C) Soft blue
flames--Normal
for natural gas
If burner flames look like (A),call for service. Normal burner
flames should look like(B)or (C),depending on the type of gas
gouuse.
With LPgas,some yellow tipping on outercones is normal.
[] CHECK IGNITION OF OVEN BURNER
Theovenis designedto operatequietlgand automaticallg.
Tooperatethe oven,pressthe Bakepad and then pressthe
number padsuntil 350 ° appearsin the display.Touchthe
Start/On pad.After 30-90 seconds,the ovenburner will ignite
and burn until the set temperatureis reached. T heoven burner
will continueto cycleon and off asnecessaryto maintain
the ovenat the temperatureindicatedby the display.
Tocheckignitionof the broil burner,touch the Broil Hi/Lo pad
and then the Start/On pad.After 30-90 seconds,the broil
burner will ignite.
Electricignition models requireelectricalpowerto operate.
In caseof a poweroutage,the ovenburnerson these models
cannot be lit manually with a match. Gaswill not flow unless
the glow bar is hot.
If the ovenis in usewhen a poweroutage occurs,the burner will
shut off and cannot be relituntil power isrestored.
42