GE EGR3000 Owner's Manual page 28

m
ul
O
B
u_
_c
¢
4,
£
4,
c
!ii@i_iiii/i
iii,iiiii_i_iiiiiiii'iiii
iiiii',iiiFiiii_ii,lii
iiiiii_'_iiiii
0
¢
t
0
m
F,
m
L.
0
0..
0,,
o
E
u_
0
J
Care and cleaning of the range.
Use a sewing needle or twist-tie
to unclog the srnatl hole in the burner
head.
Burner Caps and Heads
NOTE:Before removing the burner caps
and heads, remember their size and
location. Replace them in the same
location after cleaning.
Burner caps
Lift off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic scouring
pad to remove burned-on food particles.
Burner heads
For proper ignition, make sure the small hole
in the section that fits over the electrode is
kept open. A sewing needle or wire twist-tie
works well to unclog it.
Theslits in the burner heads must be kept
clean at a!! times for an even, unhampered
flame.
Cloggedor dirtg burner ports or electrodes
will not allow the burner to operate properly.
Ang spill on or around an electrode must
be carefullg cleaned. Take care to not hit
an electrode with anything hard or it could
be damaged.
You should clean the burner caps and
burner heads routinelg, especiallg after bad
spillovers,which could clog the openings
in the burner heads. Lift off when cool.
To remove burned-on food, soak the burner
heads in a solution of mild liquid detergent
and hot water for 20-]0 minutes. For more
stubborn stains, use a toothbrush.
After cleaning
Before putting the burner caps and heads
back, shake out excess water and then dry
them thoroughly by setting in a warm oven
for ]0 minutes.
NOTE:Do not use stee! woo! or scouring
powders to clean the burners.
Replacement
Replaceburner heads over the electrodes
on the cooktop, in the correct locations
according to their size.
On some models:
Medium head small head
and Cap andcap
Frontof rang e
and Cap and cap
On some models:
Mediurn head small head
and cap andcap
(
, FrontOfrange
Medium head Largehead
and cap and cap
Hake sure the slot in the burner head
is positioned over the electrode.
Replacethe matching size caps onto
the heads.
Hake sure that the heads and caps are
replaced in the correct locations.
NOTE:On some models, the burners are
a!! the same size and power.
28