ICON Health & Fitness NordicTrack T6.5 S User Manual page 27

Table of Contents

Advertisement

SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the five #8 x
3/4" Screws (2), and carefully pivot off the Motor
Hood (65).
a
65
2
Next, locate the Reed Switch (52) and the Magnet
(51) on the left side of the Pulley (49). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in.
(3 mm). If necessary, loosen the #8 x 3/4" Truss
Head Screw (110), move the Reed Switch slightly,
and then retighten the Screw. Reattach the Motor
Hood (see above), and walk on the treadmill for a
few minutes to check for a correct speed reading.
Top
View
52
110
1/8 in.
SYMPTOM: The walking belt slows when walked on
a. If an extension cord is needed, use only a 3-conduc-
b. If the walking belt is overtightened, treadmill
2
2
2
c. Your treadmill features a walking belt coated with
49
51
d. If the walking belt still slows when walked on, see
27
tor, 14-gauge (2 mm
) cord that is no longer than
2
5 ft. (1.5 m).
performance may decrease and the walking belt
may become damaged. Remove the key and
UNPLUG THE POWER CORD. Using the hex key,
turn both idler roller screws (C) counterclockwise,
1/4 of a turn. When the walking belt is properly
tightened, you should be able to lift each edge of
the walking belt 2 to 3 in. (5 to 7 cm) off the walking
platform. Be careful to keep the walking belt
centered. Then, plug in the power cord, insert the
key, and walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
b
2–3 in.
C
C
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances
to the walking belt or the walking platform
unless instructed to do so by an authorized
service representative. Such substances
may deteriorate the walking belt and cause
excessive wear. If you suspect that the walking
belt needs more lubricant, see the front cover of
this manual.
the front cover of this manual.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ntl17915-int.0

Table of Contents