Advertisement
DC8200 Series
DC8210 with A11 or A12 Unitrol Arm Installation
Installation Instructions
1
DC8230 Pull Side Track Installation (cont.)
D. Attach track to frame.
With the spring buffer toward hinge edge of frame and
open side facing down, fasten track assembly to frame
as shown.
F. Place slide arm on pinion shaft.
Place the slide arm and two washers on the pinion shaft, indexed
as shown below.
Secure the arm with the arm screw and washer as indicated.
H. Adjust door opening / hold open angle.
Open the door until the slider is against the cushioned
stop or engaged in hold open (A1 option only).
Remove the 9/64" hex drive socket head screw from
the arm.
Open the door to the desired angle and install the
hex drive screw into the adjusting rod hole that is
aligned with the hold in the adjusting tube.
I. Adjust closer: Refer to page 6
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2006, 2009, 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY
Access and Egress Hardware Group, Inc. is prohibited.
Approved 2022-12-12
E. Adjust arm to shortest length.
Install 9/64" hex drive socket head screw from screw pack to the
arm's shortest length as shown below.
G. Insert arm stud into slide block.
1. Insert the arm stud into the slide block of the track assembly.
2. Secure the arm stud by pushing in the retainer clip that
extends from the slide block in the track until it is flush with
the slide block.
J. Engage/Disengage Hold Open (A1 Option only):
Refer to page 7
3
80-9380-8006-152 Rev 3 11/22
Advertisement
