Using Accessories - Kärcher SC 4 Manual

Press the steam lever.
Figure
4
Steam comes out.
The equipment is now ready for operation.
Filling with water
If the steam boiler contains little water or
is empty, the water shortage control light
flashes red and a beep will sound.
Fill the water container vertically with
tap water or with a mixture of tap water
and no more than 50% distilled water,
up to the «MAX» mark.
Note
The water pump fills the boiler with steam
at intervals. When filled appropriately, the
red water shortage indicator light goes out.
The equipment is ready for operation.
Adjusting the steam volume
The outgoing steam volume is adjusted
using the steam volume selector switch.
The selector switch has 3 positions:
Maximum steam volume
Reduced steam volume
Without steam, it is safe
for children.
Note
In this position, the
steam lever cannot
be operated
1. Move the steam volume selector switch
to select the necessary amount.
2. Press the steam lever.
3. Before starting cleaning, point the
steam gun at a towel until the steam
comes out evenly.
Note:
Heating in the steam cleaning device turns
on repeatedly during operation in order to
28
keep the boiler pressure constant. When
doing so, the green – heating – control
light comes on.
Equipment shutdown
Figure
5
Press the OFF switch.
The equipment is off.
Press the steam lever until steam
comes out.
Figure
6
The boiler has no pressure.
Move the child lock (steam volume
selector switch) backward.
The steam lever is blocked.
Unplug the power plug from the outlet.
Empty the water container.
Storing the equipment
Figures y
I J
Secure extension tubes to the large
accessory holders.
Fit the hand nozzle and the jet nozzle
onto 1 extension tube each.
Attach the large round brushes to the
jet nozzle.
Do not connect round brushes or
nozzles to the mid-sized accessory
holders.
Hang the floor nozzle on the support.
Wind the steam hose around the
extension tube and connect the steam
gun to the floor nozzle.
Wind the power cord around the
extension tube.
Insert the mains cord into the accessory
compartment.
Store the equipment in a cool location
protected from frost.
Using the accessories
Important usage instructions
Cleaning floor surfaces
Sweeping or vacuuming the floor before
using the steam cleaner is recommended.
This will remove loose dirt/particles from
the floor before wet cleaning.