HOMCOM 820-359V80 Owner's Manual page 6

PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power
outlet. and turn on the power switch in the rear of the unit. Only operate heater in upright
position.
Insert 1 CR2025 batteries into the remote control before using (Batteries Not Included)
Remote control
OPERATING INSTRUCTIONS
1. Start and select working mode
Battery cover
Turn the heater on by pressing the ON/OFF button on
the control panel or by pressing the Power button on
the supplied remote control.
Once power is off, heating element will stop working at
first. Fan will prolong working for 3 min to emit plenty of
heat inside. This mark will indicate running during the 3
min.
Select a heat Mode
Press the MODE button to toggle between the three
heat modes.
High Mode uses 1500W; Low Mode uses 1000W. ECO
mode is an Economic Energy Saving Function. When
ECO mode is chosen, the heater will manage itself from
less to more heating power (watts) in an attempt to
maintain a constant warm 68℉.
6
Battery